|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
02-28-2014, 09:19 PM
|
#1 |
|
Not Yet Wild
Join Date: Aug 2010
Location: Louisiana
Posts: 15
|
Programming Alltrax controller
I have almost completed my 48 volt upgrade to my cart. I have installed all of the new parts, motor, wires, batteries, F/R contactor, solenoid, etc. I am waiting on my charger, which should be here Monday.
My question is, do I need to reprogram my Alltrax 400 amp controller to use it in the new 48volt system? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-01-2014, 08:21 AM
|
#2 |
|
Techno-Nerd
 Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Programming Alltrax controller
Yes, the Under Volt and the Over Volt settings will most likely be wrong if it was previously used with a 36V system.
Under should be about 36V and Over should be set to Max (60V or more) Also, you may have to tone down the Throttle Up Rate to keep from spinning the tires or doing wheelies.  |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Bad OBC after programming Alltrax controller? possible? | Electric Club Car | |||
| Controller (Alltrax) Programming tips | Electric Club Car | |||
| Alltrax Controller Programming for Precedent | Electric Club Car | |||
| Programming alltrax controller | Electric EZGO | |||
| what is the best programming for an alltrax controller | Electric EZGO | |||
Linear Mode
