07-13-2014, 08:33 PM | #1 |
Not Yet Wild
Join Date: Feb 2009
Posts: 70
|
91 ezgo
need help will go in reverse ,but no forward .91 ezgo 36v. have changed fnr switch,no help.checked all wires tight. I know solenoid and pot is good because of reverse.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-14-2014, 10:49 AM | #2 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 91 ezgo
Quote:
If not, the problem is associated with MS-2 on F/R assembly. Probably not the switch itself, but something like the indentation in the cam the roller is supposed to fall into is full of debris, or the cam isn't being rotated all the way to the Forward mechanical stop. If the solenoid is clicking in Forward, pull the black and white wires from the pot-box off the controller and measure the Ohms between them while F/R is in F. Should be about 0-5k. If it goes above about 7K, the controller thinks the pot is open and won't pass amps to motor. Note: When F/R is in R, a fixed 5K resistor is placed in parallel with the Pot-Box, so the controller sees 0-2.5k. Therefore, if the pot was out of range in F, it might very well be in range in R. |
|
07-14-2014, 08:21 PM | #3 |
Not Yet Wild
Join Date: Feb 2009
Posts: 70
|
Re: 91 ezgo
the relay clicks in forward. will check the pot box tomorrow. thank u
|
07-15-2014, 08:24 PM | #4 |
Not Yet Wild
Join Date: Feb 2009
Posts: 70
|
Re: 91 ezgo
changed fnr with good switch.same problem.switched wires on fnr. f make the motor go in revers.r will not go forward.changed wires back. reverse ok.forward still no go. pot checks out 0,0-5k.i think problem is in motor.while holding pedal down, I rolled tire and it started going. will pull my plum quick of and install stock to see.
|
07-16-2014, 09:12 AM | #5 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 91 ezgo
Quote:
|
|
07-16-2014, 08:19 PM | #6 |
Not Yet Wild
Join Date: Feb 2009
Posts: 70
|
Re: 91 ezgo
it never ran in forward just reverse.r ran reverse,when I changed cables f ran reverse, changed fnr with another same problem. I held pedal dowen in forward and rolled tire by hand and it started up. thinking something in motor will install stock motor this weekend and see. haven't got anything but time to lose/
|
07-17-2014, 06:04 AM | #7 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 91 ezgo
Quote:
So the motor will run CW but not CCW (or vice versa), unless it is nudged by hand. That does point to a motor issue. |
|