|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
09-05-2012, 10:04 AM | #1 |
Getting Wild
Join Date: Aug 2012
Location: Pennsylvania
Posts: 76
|
King Pin bushings
Is there a specific way to remove the kingpin from a G8? I never done one but the bushings are shot and would like to replace.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-05-2012, 10:09 AM | #2 |
Never really finished
Join Date: Jun 2010
Location: Georgia
Posts: 1,102
|
Re: King Pin bushings
Mac...if its like mine (G2) I had to soak the pins for several hours with PB blaster to get them to let go. Mine has a little roll pin that has to be driven out for the pin to slide out. The process is pretty easy after that. Did you get a kit with the pins, all the bushings and rubber covers?
|
09-05-2012, 08:25 PM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: King Pin bushings
You are correct about the roll-pin in the spindle. Also, no special tools are needed, only a hammer and punch, I also use a 3/8 drive extension with a socket installed upside down as a driver to drive in the new bushings. Be sure to get the metal bushings with rubber caps, dont accept the plastic type that were installed on the assy line, at our shop we don't even offer those....START HERE TO REPLACE BUSHINGS> Fetch can of Brake-clean and rags. Remove both front wheels. After driving out roll-pin, Usually, the kingpin will still be stuck in the spindle. first put the punch through the hole in the bottom of the kingpin and try to twist back-n-forth to get the kingpin out. When this method fails (50% chance), use the punch to punch through the top of the plastic bushing and use the punch and hammer to drive the pin out through the bottom. Clean the pin and the hole inside the spindle where the pin was until the pin slides in easy. Inspect the kingpin for damage from wearing through the old bushing, the kingpins are Very hard metal and 99% of the time are ok. (any kingpin you replace goes in your toolbox as a great quality punch for future use). Clean the washer that goes on top of spindle. Set spindle, kingpin and washer to the side out of your way. Remove the old bushings (carefully with hammer and punch). clean the end of a-arm where the bushings go. Orient the new taller upper bushing so that the split faces you, slide the 3/8 extension through the bottom hole and install your upside-down socket on the extension. use the socket/extension to drive in the new bushing. Repeat this procedure for the bottom bushing, BUT with the split facing AWAY from you on the bottom one. Now test fit the kingpin into both bushings and check for free turning movement. If it doesn't turn freely, gently hit the kingpin from several directions with the hammer untill it moves freely (This might sound bad, but it works and doesn't hurt the kingpin or bushings). Smear some grease in the bushings, on the kingpin, and on the washer. Install all parts as they were removed, DON'T forget the roll-pin when you have put the kingpin back in! REPEAT for other side. Now enjoy years of trouble free service! This job takes about 45 mins, and is a huge improvement in steering feel.
|
09-05-2012, 11:07 PM | #4 | |
Getting Wild
Join Date: Aug 2012
Location: Pennsylvania
Posts: 76
|
Re: King Pin bushings
Quote:
|
|
09-05-2012, 11:10 PM | #5 | |
Getting Wild
Join Date: Aug 2012
Location: Pennsylvania
Posts: 76
|
Re: King Pin bushings
Quote:
|
|
09-06-2012, 05:36 AM | #6 |
Never really finished
Join Date: Jun 2010
Location: Georgia
Posts: 1,102
|
Re: King Pin bushings
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G16 king pin bushings | Gas Yamaha | |||
New Club Car Parts-Headlight, Key Switch, Bushings, King Pin | Golf Carts and Parts | |||
Bushings | Electric EZGO | |||
Tell me about king pin bushings.. | Gas Yamaha | |||
about king pins and bushings | Electric Club Car |