Ez go lift

Gamehunter

I have a 98 txt that came from the factory with a rear seat I put an ezgo 4" lift on and it sets lower in the front than the back. My question is. Is this because the springs are heavier in the rear because of the factory seat and what are my options to fix the problem.


---
I am here: http://tapatalk.com/map.php?l4ghcu

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

gotmud10

Hd front leafs will lift it up about an inch or you can cut 1in square stock and get 1in longer bolts that hold your stock springs to your front axle weldament. Basically sandwiching the square stock between axle and the leaf spring. A buddy of mine added 3 blocks - 2in front and 1 in rear for an additional 3in lift up front

patgrim00

I got 2" on my ezgo just by adding a piece of half inch plate that bridged the front 2 bolts on the rear of the front spring then I cranked down the single back spring

fildogg

depending on the height you are looking for, you could place the leaf springs on the rear ON TOP of the axel if they are below it, that will lower the rear, and probably get you back to level.

The Oracle

I did the block thing to balance mine out and it worked well.