|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
01-25-2016, 11:10 AM | #1 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
2002 ds drive clutch bolt torque
What is the drive clutch bolt with reverse threads torque spec?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-25-2016, 07:05 PM | #2 |
Gone Wild
Join Date: Oct 2009
Location: Lee County, Georgia
Posts: 521
|
Re: 2002 ds drive clutch bolt torque
From a 2005 DS service manual
DRIVE CLUTCH INSTALLATION 1. Place the drive clutch assembly on the crankshaft taper. Position the mounting washer (with the green side facing out) on the bolt (17) and start the bolt into the crankshaft (Figure 17-5, Page 17-6). See following NOTE. NOTE: The drive clutch mounting bolt has left-hand threads. 2. Tighten the drive clutch retaining bolt (17) to 25 ft-lb (33.9 N·m) (Figure 17-5, Page 17-6). 3. Install the starter/generator belt and adjust belt tension as instructed. See Belt Tension Adjustment, Section 12, Page 12-11. Tighten the starter/generator mounting hardware to 23 ft-lb (31.2 N·m) and the adjusting hardware to 13 ft-lb (17.6 N·m). 4. Install the drive belt as instructed. See Drive Belt Installation on page 17-3. 5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m). See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/ N 1014305) to minimize corrosion. 6. Connect the spark plug wire to the plug. 7. Drive the vehicle and check for proper operation. |
|
|
Similar Threads | ||||
Thread | Forum | |||
83 Columbia Clutch Bolt Torque | Gas Columbia ParCar | |||
2008 Drive Torque on 'Kingpin' bolt | Gas Yamaha | |||
Primary clutch bolt torque | Gas Yamaha | |||
Torque for clutch bolt | Gas Club Car | |||
96 DS stock drive clutch bolt size (exterior bolt) | Gas Club Car |