![]() |
|
Gas Club Car Gas DS, and Precedent golf cars |
![]() ![]() |
Thread Tools | Display Modes |
![]() | #21 |
Bad *** Speller! ![]() Join Date: Oct 2009 Location: Columbus, Ohio
Posts: 1,338
| ![]() |
![]() | ![]() |
![]() | |
![]() __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum | |
![]() | #22 |
Not Yet Wild ![]() Join Date: Aug 2009 Location: sw pa steelers/ pens country
Posts: 68
| ![]() yes it is 1 inch angle with some nylon bushings in between . does have about inch clearance from intake. i used a piece or 1/4-28 althread for my throttle lever. as for the fuel i asked the question a few weeks ago ,alot of people tapped off the intake breather says it works fine. im trying that now if that dont work might punch a 1/4" tube in the carb block. hope scotty doesnt get mad i rattle canned his design. |
![]() | ![]() |
![]() | #23 |
go to cartsunlimited.net ![]() ![]() Join Date: Dec 2007 Location: Southern California
Posts: 67,567
| ![]() Heck no! That looks Good ![]() Neat how a pivot point turns a push rod into a pull rod.... |
![]() | ![]() |
![]() | #24 |
Not Yet Wild ![]() Join Date: Aug 2009 Location: sw pa steelers/ pens country
Posts: 68
| ![]() guess did learn somthing ing af lol |
![]() | ![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() | ||||
Thread | Forum | |||
16hp clone / driven Clutch | Gas Yamaha | |||
EZGO to 16hp Clone & More | Big Block Talk! | |||
97 ez go txt 16hp clone swap completed. | Big Block Talk! | |||
Throttle Linkage | Big Block Talk! | |||
Valve setting on 16hp clone? | Big Block Talk! |