lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Club Car
Gas Club Car Gas DS, and Precedent golf cars



Post New Thread  Reply
Thread Tools Display Modes
Unread 05-12-2008, 08:21 PM   #1
Gone Wild
 
Bulky's Avatar
Club Car
 
Join Date: Dec 2007
Location: Rhode Island
Posts: 281
Default Key switch & Kill switch question

When I bought my 1992 gas Club Car, the previous owner had wired it to stay running when stopped (bypassed pedal start). To shut the motor off I must pull a kill switch. Is there a way I can get it to shut off when I turn the key off?

Thanks
Bulky is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 05-13-2008, 08:58 PM   #2
Frog Hunter
 
4x4 CC's Avatar
Club Car
 
Join Date: Dec 2006
Location: Little Rock, Ar
Posts: 1,161
Default Re: Key switch & Kill switch question

I am sure you can. I have no idea on how. Try finding some wiring diagrams and you'll figure it out!
4x4 CC is offline   Reply With Quote
Unread 10-26-2009, 10:51 PM   #3
Not Yet Wild
 
Join Date: Sep 2009
Posts: 13
Default Re: Key switch & Kill switch question

if it done properly you should be able to take wire off the kill switch and place it on the ignition barrel at the off point. If it was me i would follow kill switch wire back to original location he might have taken one off pedal and used it , if that the case just reconect it
wyksey is offline   Reply With Quote
Unread 10-26-2009, 11:46 PM   #4
Gone Crazy
 
Join Date: Jan 2007
Location: Chesterfield, Va
Posts: 5,066
Default Re: Key switch & Kill switch question

Sous like he did more than just bypass the pedal switch if he added a push/pull killswitch.
Follow the wiring diagram below to put it back to stock configeration for the safety of everyone.

http://img219.imageshack.us/i/wiringha5.jpg/
crash12888 is offline   Reply With Quote
Unread 10-27-2009, 02:23 AM   #5
BGW Sponsor
 
scottyb's Avatar
E-Z-GO
 
Join Date: Dec 2007
Location: Southern California
Posts: 66,156
Default Re: Key switch & Kill switch question

These motors "kill" the ignition by connecting the ignitor or coil to a battery ground. You would need a 5 or 6 terminal ignition switch which has a ground post present and a place for your ignition wire so it could close that circuit when off.... THat is esentially what the kill button you have is doing It may be more trouble than it is worth...
scottyb is offline   Reply With Quote
Unread 07-14-2010, 12:58 PM   #6
Getting Wild
 
CLUBCARGREENMACHINE's Avatar
Club Car
 
Join Date: Dec 2009
Posts: 75
Default Re: Key switch & Kill switch question

disconnect his killswitch contraption.... then in the black box in the motor compartment, there is two microswitches. the bottom one has a wire going to a ground post. disconnect the ground, and tape it up. now the cart will start with the pedal, and kill with the key. but u do know that he must have toned the motor down to do this, because if u dont, the cart will keep going after u stop. id just disconnect it, and extend the throttle cable going into the black box all the way out, and ur cart will fly!!
CLUBCARGREENMACHINE is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
New Ignition Switch Gas EZGO
36V & 72V with switch? Extreme DC!
Gas Guy on Electric F/R Switch ? Electric EZGO
its switch Electric EZGO
F/R switch looks a little weathered! Electric Club Car


All times are GMT -5. The time now is 01:23 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.