06-17-2013, 07:26 AM | #1 |
Gone Broke
Join Date: Oct 2011
Location: Galveston, Texas
Posts: 1,592
|
hub question???
yesterday, after cleaning up from a day at the beach,i was wiping down the rims,on the old cart and noticed that the wheel had quiet a bit of play were it mounts to the hub,so i popped the plastic cover to tighten hub nut, and it was tight. and could not tighten it up more because i ran out of thread. is it suppose to have play or slop???? or can i add washers to snug it up were it still will roll freely?????
thanks pcc |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-17-2013, 08:39 AM | #2 |
Gone Wild
Join Date: Jun 2008
Location: Austin, Tx area
Posts: 209
|
Re: hub question???
How old is it? And have you made sure it's not the spindle bushings and/or upper control arm bushings....
|
06-17-2013, 08:41 AM | #3 |
Gone Wild
Join Date: Jun 2008
Location: Austin, Tx area
Posts: 209
|
Re: hub question???
I may have misread that. You shouldn't run out of thread on the hub. Maybe the spindle though? More info, please....
|
06-20-2013, 10:14 PM | #4 |
Gone Wild
Join Date: Jan 2007
Location: La Porte Indiana
Posts: 1,392
|
Re: hub question???
I think its 03 and newer that have the plastic dust covers in the middle of the hub. these use a sealed bearing as opposed to the older ones with metal covers that had tapered bearings.
once the ones on a newer cart are tight, they are tight. replace bearings. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1990 Club car With flat head Rev limiter question and govenor question | Gas Club Car |