07-06-2011, 10:07 PM | #1 |
Not Yet Wild
Join Date: Jun 2011
Location: Mount Juliet, TN
Posts: 13
|
Need a measurement
In my previous posts I mentioned that we had to cut the primary drive pulley off the crankshaft on my 92 Par Car only to find out afterwards that the clutch assembly is no longer available. Well, with no other option left we fabricated a new one by reverse engineering from what was left of the original that we cut off. The only issue we have left is that we had to guess on one of the measurements since material was missing from the original where we cut it. Could someone please provide me with either the length of the base section of the shaft or the distance between the fixed pulley half and the centrifugal pulley half while at rest so that we can make the final adjustments. It would be greatly appreciated.
Thanks in advance. Here are some photos of the new fixed pulley half and the measurement needed. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Need a measurement / belt slack | Gas Yamaha | |||
measurement help | Design Center | |||
Only because my cart is at the CG I need a pic and measurement...please | Gas EZGO | |||
need a measurement | Electric EZGO | |||
Need A Measurement | Electric EZGO |