Shuttle 4 body parts vs TXT.

BigDfromTN

I have a 2010 Shuttle 4 I recently bought. The body appears to be the same as a TXT model. So, Do all body accessories like Fender Flares, Flip Flop seat, trailer hitch, dash panels etc. for a TXT fit my cart? (Photo in Avatar)

Main reason for asking is that the lift kit was different. I think that is because it had the Kawasaki engine and rear end. ???

TIA for all the help!

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

BrewCityMusic

As a rule all the cosmetic parts are the same, just buy for a TXT

BigDfromTN

Thanks!

jfsegar

How did you fit the lift kit on the rear axle?

BigDfromTN

The kit was made for this cart. Just remove the rear springs, slide them over the rear axle, insert blocks and bolt it back up. Did front and rear by myself in about 2 hours or less. Really easy mod.

Mine has the Kawasaki engine and is a bit different than most TXT carts. No need to remove brake cables or reroute them. Once the axle is on top, insert block, move old bottom plate with shock attached to top of spring and install supplied U-bolts and nuts.

Only thing I wish I had done different was lift cart higher off the ground on the rear. I used jack stands at the lowest setting on the frame. Should have raised it up higher to make it easier.

there are several You-Tube videos that show the procedure in a clear manner.

jfsegar

Appreciate the response. Does your cart have the E brake and F/R on the front seat and do the wheels have 5 lug nuts? That's the issue I think I'm running into.

I've done a lift kit on a club car before no problem. I'm thinking this one may be problematic. I may be able to get by with a small lift kit on the front and using shackles on the back from what I've read.

BigDfromTN

No E brake, Only the regular hill stop/brake lock.
Not sure what you mean by F/R so I assume not... Shifter is in front of seat in the seat pod.
Mine has 4 lug nuts like a standard cart.

the rear block for mine kit was Aluminum and fit over the axle and had a hole for a pin in the rear axle housing. Call around... Im sure some one makes a kit for it. Maybe even post a question in the "Lifted" section and there are lots of more knowledgeable folks there glad to help.

What kind of cart do you have?

jfsegar

Gotcha. Thanks for the quick response.

The one im looking at has a lever you pull on for forward/reverse and also an e brake lever. Both are mounted on the front seat beside some cupholders. It's a totally different set up.

Thanks.

BigDfromTN

Glad to TRY and help...

Ease on over to the "Lifted carts" section and Im sure someone there will know EXACTLY what you need.