2001 Ezgo gas have question about cylinder bore

Mazak1131 · 06-09-2015, 03:56 PM

I have a 2001 Ezgo with a 295cc Robin engine in it. My question is std bore is 2.519 to 2.520. With a set of bore mics I am 2.521 so I am .001 over std. Would I be ok with going with std rings or should I go with oversized rings?

MarineGrunt · 06-12-2015, 08:54 AM

If it were me I would get some .5 over piston and rings and have it bored. You know it'll be done right then. I recently had a head bored for an old Honda 3 wheeler and it cost me $35. That was only one cylinder though.

06-09-2015, 03:56 PM	#1
Mazak1131 Not Yet Wild Join Date: Jun 2015 Posts: 2	2001 Ezgo gas have question about cylinder bore I have a 2001 Ezgo with a 295cc Robin engine in it. My question is std bore is 2.519 to 2.520. With a set of bore mics I am 2.521 so I am .001 over std. Would I be ok with going with std rings or should I go with oversized rings?
Mazak1131 Not Yet Wild Join Date: Jun 2015 Posts: 2

06-12-2015, 08:54 AM	#2
MarineGrunt Getting Wild Join Date: Dec 2012 Posts: 79	Re: 2001 Ezgo gas have question about cylinder bore If it were me I would get some .5 over piston and rings and have it bored. You know it'll be done right then. I recently had a head bored for an old Honda 3 wheeler and it cost me $35. That was only one cylinder though.
MarineGrunt Getting Wild Join Date: Dec 2012 Posts: 79

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Forum
Plan to over bore gualded cylinder on my G1 need specs	Gas Yamaha
Bore 244 oversize cylinder	Gas EZGO
measuring cylinder bore	Gas EZGO
G14 Cylinder Bore Damaged	Gas Yamaha
Overhauling my G-9.. cylinder bore ??	Gas Yamaha

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum