10-11-2017, 09:02 AM | #1 |
Not Yet Wild
Join Date: Aug 2015
Posts: 62
|
295 bored to 350
Has anyone built a 295 bored out to a 350. I know a couple companies do this. From what I can tell from searching obviously you need the cylinders bored and then have the block decked around .080 due to the difference in wrist pin location between the 295 and 350 pistons. Any advice would be appreciated. Thank you!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-15-2017, 04:37 PM | #2 |
Gone Wild
Join Date: Apr 2012
Location: Dansville, NY
Posts: 396
|
Re: 295 bored to 350
you need to use the 350 crank with the 350 pistons, no decking needed.
|
10-15-2017, 05:53 PM | #3 |
Not Yet Wild
Join Date: Aug 2015
Posts: 62
|
Re: 295 bored to 350
Thank you! I sourced a 350 crank but the same person also had a mci 350 so I ended up getting that. It is the correct motor for my cart and was in much better shape. Rings and gaskets and it will be good to go. Maybe I will build the 295 to sell.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Bored with Low so Lifted it up a bit | Members Rides | |||
OK, so I was bored. | Design Center |