|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-25-2018, 03:21 PM | #1 |
Not Yet Wild
Join Date: Aug 2011
Posts: 13
|
need manual for 98 robin 295
need manual to rebuild 98 robin 295
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-25-2018, 03:57 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: need manual for 98 robin 295
I have the engine shop manual for 295 and 350 engines. $60 shipped
|
04-29-2018, 05:17 PM | #3 |
Crazy Wild
Join Date: Jun 2015
Location: Carolina Lowcountry
Posts: 796
|
Re: need manual for 98 robin 295
http://www.buggiesgonewild.com/ezgo-...iagram-id.html
Maybe this link will help. http://products.jacobsen.com/img/manuals/27615-g01.pdf |
04-29-2018, 08:37 PM | #4 | |
Not Yet Wild
Join Date: Aug 2011
Posts: 13
|
Re: need manual for 98 robin 295
Quote:
|
|
05-01-2018, 03:23 PM | #5 |
Not Yet Wild
Join Date: Aug 2011
Posts: 13
|
Re: need manual for 98 robin 295
Got 295 robin rebuilt. Now runs good wide open but let off alittle and it cut off and on. Checked valves and replaced carb no help fuel pump pumping good, also coughs back through carb occasionly. Any help appreciated. Thanks
|
05-01-2018, 04:37 PM | #6 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: need manual for 98 robin 295
Did you time the cam per the manual?
|
05-01-2018, 07:09 PM | #7 |
Not Yet Wild
Join Date: Aug 2011
Posts: 13
|
Re: need manual for 98 robin 295
Thoucht i did. But now doubting. Can i pull timing belt cover with engine in?
|
05-01-2018, 07:27 PM | #8 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: need manual for 98 robin 295
Clutch needs to come off but it can be done
|
05-02-2018, 03:29 AM | #9 |
British born Nincompoop
Join Date: Feb 2007
Location: United Kingdom
Posts: 2,461
|
Re: need manual for 98 robin 295
I doubt it would be the valve timing as it runs fine open throttle. More likely to be governor adjustment or throttle cable adjustment. Lock the gears in neutral at the axle shifter (should be a pin you can pull and rotate 180 degrees ) and wiggle the gearshift to make sure it is in neutral while turning the rear clutch to make sure the wheels dont turn. Or jack the rear wheels off the ground. then with your foot, slowly push down on the gas pedal and you should hear a very slight click from under the floor by the pedal. once you have identified this you then slowly push the pedal and if the throttle starts to open on the carb before you hear the click, you will need to adjust the cable or the throttle link between the governor and carb. Some people adjust it like this to make the cart go faster, but it messes up the switch timing. If the carb is open before the switch activates it make slow driving extremely jerky as the ignition is being switched on and off while the carb is open. also check that the throttle stop screw on the drivers side of the carb is not screwed in too much and holding the butterfly open on the carb. if so, unscrew it and launch it into space as it is not needed on these engines. or put somewhere safe just in case LOL
This will also make the cart backfire causing the "cough" |
05-02-2018, 03:34 AM | #10 |
British born Nincompoop
Join Date: Feb 2007
Location: United Kingdom
Posts: 2,461
|
Re: need manual for 98 robin 295
If i am right, you can pay me tomorrow. I take all currencies and beer.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Robin EC-25-3pg service manual | Gas EZGO | |||
Help with a 1998 robin eh29 manual | Gas EZGO | |||
1985 Robin EC25-2PG Manual | Gas EZGO | |||
Robin EC25 manual | Clone Engine Swaps |