need to know

puller

I just received a new driven clutch from Tom at c.c.p.When I went to take off the old one nothing was holding it on.Doesn't it have a bolt?If so what size bolt?It is on my 1990 marathon.
Ritchie

TheNewGuy

Check this thread out, should be about the same. Thanks mb523!!

Removing an EZGO clutch

Ron

If you can't run with the BIG DOGS...stay on the porch

Please Visit Our Sponsors

TheBadBoyG9 * Frame Mod * New Exhaust
Marathon Project

Bob-0

For the Driven clutch (on rear end) there is a bolt and special washer that holds it on the input shaft.

Feel inside the middle of the driven clutch (if it is still on the rear end), and check to see if the bolt sheared off. If it did not, you may not need the new clutch.

If the bolt isn't there, the driven clutch should slide off fairly easily compared to normal. But check and see if the bolt sheered off... that would be a can of worms if it did.... a lot of precise work needed... the bolts usually don't shear clean, so starting a guide hole for the easy-out is hard to do.

Bob

mphillip

Glad to see you back Bob... Thanks for the info

puller

Thanks for the info.the bolt is not broken just missing.Where can I find the special washer?

Bob-0

Howdy Mr.Phillip

Puller, the best that I can suggest is to get it from your local authorized E-Z-GO dealer. That should be the fastest way to get you on the road again.

You will need the Driven clutch bolt, Lock Washer, and the Thrust washer.... those three items. A dealer should have those in stock, if not then their probably a little shaddy

The special washer... thrust washer... is shaped much like a... T ... it helps guide the bolt, and give the lock washer some hardened metal to grip.

Have a great one,
Bob