|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-13-2010, 05:22 PM | #1 |
Not Yet Wild
Join Date: May 2009
Location: Pickering, Ontario. Canada
Posts: 4
|
97 workhorse runs on one cylinder only
I just bought a workhorse, it had been sitting for about 4 months. I put in a new battery and it ran fine. I got it home drove it around for awhile, all seemed fine. as the days went on it became harder and harder to get it started. Today I could not start it at all. I found that it does start when I take the plug wire off the second cylinder I swapped the plugs and same thing . I do have spark from both ignition wires , but if I try to start with only the second cylinder or both wires on , it will not start. Any ideas what to do next?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-13-2010, 05:33 PM | #2 |
Gone Wild
Join Date: Aug 2009
Location: Santuck,Al
Posts: 1,747
|
Re: 97 workhorse runs on one cylinder only
If possible do a compression check & check valve adjustment.Also if you don't have a compression guage remove the sparkplugs and insert a screwdriver into each cylinder then while turning the clutch by hand be sure both of the pistons are moving up & down (indicated by the movement of the screwdrivers) to rule out a broken rod.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Runs 10 minutes then shuts off, wait 5 then runs again... | Electric EZGO | |||
Reverse...runs awesome Forward..runs bad | Gas EZGO | |||
Workhorse runs intermittently | Gas EZGO | |||
EZ GO Workhorse runs, but does not move | Gas EZGO | |||
No Compression One Cylinder | Gas EZGO |