89 ez-go not upshifting on secondary clutch

turbopower

Hello I have some questions my cart seems very slow revs high I think around 4000 rpm's
but I can out run it on foot fast pace walk things I have done is checked the compression it is at 120 psi and changed carb new one changed the whole rear with another cart I have including clutch that was working fine till I broke piston on my old cart I installed a new plug
if I raise cart off the ground it will up shift but takes about 3-5 seconds for this to happen I used the belt from my other 89 ez-go which performed better than this cart and it only had 85 ponds of compression
I even popped the carb linkage off and ran throttle by hand no difference
does the governor control up shift of clutch other than means of rpm
any help info would be appreciated thanks in advance

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

popatop

Hi turbopower, Is your clutch opening up when you rev it up?

turbopower

Hello yes the clutch does open but maybe not as far as it should I have another clutch what kind of puller do I need does the clutch have a bigger threaded whole once the smaller retaining bolt is removed

thanks for your response turbopower

DOOmsman

[COLOR="Red"][it will up shift but takes about 3-5 seconds f/COLOR]

Lets look real hard at the clutches and belt
Is the belt the same size?
when you rev it on stands does the driver seem to be slow closing
on the belt or is the driven slow to open.
You may have a sticky bushing in either clutch.