lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
Thread Tools Display Modes
Unread 09-02-2018, 03:45 AM   #251
Not Yet Wild
E-Z-GO
 
Join Date: Aug 2018
Location: niota tn.
Posts: 3
Default Re: Installing HEI Ignition on 3PG Carts

Got Hei Runs Good No Trouble .
verlinks is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Unread 11-01-2018, 10:15 PM   #252
Not Yet Wild
 
Join Date: Oct 2018
Posts: 1
Default Re: Installing HEI Ignition on 3PG Carts

Quote:
Originally Posted by cbilley View Post
cleaned carbs and drained the tank replacing with fresh fuel. No luck, try's to run but just won't get up throttle to even move the cart. A few backfires, also, I switch the wires on the coil, no change.
I have the same problem with a ,1996 ezgo, did the hei conversion and it will hardly pull itself out of the shop; new plugs, wires and a high performance coil,new carb& fuel pump, even a new timing belt, no power at all ???

Sent from my Moto E (4) Plus using Tapatalk
lesterjowers1942 is offline   Reply With Quote
Unread 11-23-2018, 10:38 PM   #253
Not Yet Wild
 
Join Date: Nov 2018
Posts: 3
Default Re: Installing HEI Ignition on 3PG Carts

What was the reason you switched. I have problem with intermittent spark . Have all new electrical parts except pulsar
Hespeler88 is offline   Reply With Quote
Unread 11-23-2018, 10:40 PM   #254
Not Yet Wild
 
Join Date: Nov 2018
Posts: 3
Default Re: Installing HEI Ignition on 3PG Carts

Why the change . I have intermittent spark. All new electrical parts except pulsar .
Hespeler88 is offline   Reply With Quote
Unread 11-23-2018, 11:39 PM   #255
Test before replacing
E-Z-GO
 
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 2,313
Default Re: Installing HEI Ignition on 3PG Carts

Quote:
Originally Posted by Hespeler88 View Post
Why the change . I have intermittent spark. All new electrical parts except pulsar .
Try switching the red, and blue wires coming from the pulsar where they connect at the HEI module.
cart around is offline   Reply With Quote
Unread 11-25-2018, 07:42 AM   #256
Not Yet Wild
 
Join Date: Nov 2018
Posts: 3
Default Re: Installing HEI Ignition on 3PG Carts

Did you install this because of bad spark or inconsistency
Hespeler88 is offline   Reply With Quote
Unread 01-07-2019, 11:10 AM   #257
Not Yet Wild
 
Join Date: Oct 2013
Posts: 10
Default Re: Installing HEI Ignition on 3PG Carts

any way to check the pluser beside ohms ,I replaced the ignitor and coil and still no go, pluser reads 145 ohms
jake100 is offline   Reply With Quote
Unread 08-26-2019, 01:26 PM   #258
Not Yet Wild
 
Join Date: Aug 2019
Posts: 17
Default Re: Installing HEI Ignition on 3PG Carts

I was curios how or if this fix can work on a later model 1991, with the following diagram, showing YEL/RED to ignitor off D+ on the regulator.
Attached Images
File Type: jpg later 91 screenshot.jpg (15.0 KB, 0 views)

Last edited by squirt199; 08-26-2019 at 01:34 PM.. Reason: BAD PHOTO/DESC
squirt199 is offline   Reply With Quote
Unread 08-26-2019, 01:39 PM   #259
Not Yet Wild
 
Join Date: Aug 2019
Posts: 17
Default Re: Installing HEI Ignition on 3PG Carts

I may have answered my question above looking closer, my yel/red, is technically still connected to D on the SOL, but it is jumped off D+ on the Volt reg.

Assuming I can keep YEL/RED on D+ on volt reg and connect the other end to to B on the HEI?
squirt199 is offline   Reply With Quote
Unread 08-26-2019, 01:44 PM   #260
Not Yet Wild
 
Join Date: Aug 2019
Posts: 17
Default Re: Installing HEI Ignition on 3PG Carts

I should have summarized the problem,

New to me cart.

ezgo, 1991 2 cycle.

isnt running, has been stored for soem time. no spark situation. looking at the elec specs, I noticed YEL/RED of ignitor was connected to D- on the volt reg. Should be D+.

I switched it and now get a low spark using an inline tester. I wanted to replace the ignitor since I was unable to test it due to a lack of a VOM at the time. Being the ignitor is very expensive, and the ignition coil, equally expensive (and not sure its faulty) I thought this might suit my needs to correct the problem at a fraction of the cost. I am not a mechanic however.
squirt199 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
Top Notch Carts, Edinburgh, Indiana. Carts I've built. Members Rides
Yamaha G9-Ignition Coil & Ignition Switch-Help Gas Yamaha
Installing a DCX 400 Electric EZGO
Carts, carts, carts!!!-'01 EZ GO-$1300.00!!?? Golf Carts and Parts
Installing Light Kit G16 Gas Yamaha


All times are GMT -5. The time now is 02:17 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.