05-18-2012, 03:23 PM | #1 |
Not Yet Wild
Join Date: May 2012
Posts: 7
|
No Start Turnover
WOW...Gas, 95, Meadalist. Turned on key, pressed pedal, started and ran.
Replaced throttle cable under floor mat to gov. Now nothing, will not turn over when pedal depressed. I can cross the selenoid and starter spins ok, with key switch on it does not fire up. What in the world could have happened!!!!????? Help a brother out..............Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-20-2012, 06:53 AM | #2 |
Gone Wild
Join Date: Jan 2012
Location: Kansas City, Mo
Posts: 544
|
Re: No Start Turnover
Look at the switches on the pedal and make sure they are hooked up and check the fuse also.
|
05-20-2012, 07:46 PM | #3 |
Not Yet Wild
Join Date: May 2012
Posts: 7
|
Re: No Start Turnover
Fuse??? I followed the wire from the key switch. Green-from key switch terminal runs into floor/pedal microswitch. Turns from Green to Red at the switch...no fuse anywhere that I can see. Any suggestions?
|
05-21-2012, 08:15 AM | #4 |
Gone Wild
Join Date: Jan 2012
Location: Kansas City, Mo
Posts: 544
|
Re: No Start Turnover
Sorry I got corn-fused! I was thinking of my Club car
|
05-22-2012, 02:00 PM | #5 |
Not Yet Wild
Join Date: May 2012
Posts: 7
|
Re: No Start Turnover
Ta-Da! After many hours of getting frustrated I retraced the whole electrical system wire by wire. Each wire was in appropriate position/termination. I went as far as to buying another selenoid (automotive...do these last long? or will problems occur?) and reinspected each terminal for contact integrity. I stumbled upon the fact that the "Grounding block" terminal, the one mounted onto a bracket with the selenoid and regulator was not exactly grounding into the frame. I ran a seperate wire from this block and terminated it into the battery/frame ground. TA-DA!!!! Back into the game. Thank you for your help guys.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Yamaha G2 will turnover only when shorting across the solenoid | Gas Yamaha | |||
Too long sparkplug used, wont turnover now | Gas Club Car | |||
HELP!!!cart wont turnover | Gas EZGO | |||
g14a wont turnover | Gas Yamaha | |||
no turnover on g2? | Gas Yamaha |