Gas RXV Rhox Spindle lift kit install

smackdaddy66

So the front was a piece of cake. Done inside 30 minutes. Haven't started the back yet as it looks to be a bit tougher. Does anyone have any advise, or things to watch for? Do I really need to disconnect the brakes, and are there any special tools I should have available? Thank you!



Smackdaddy66

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

smackdaddy66

Bigger job than I wanted. U-bolts rusted and needed to be cut off. Brake cables had to be removed and rerouted. Drivers side brake cable bracket needs to be replaced with a smaller one. Battery needs to be removed to route battery cable for drivers side brake. Still need to replace front motor mount to lower front part of engine; hope I don't stretch fuel lines. Then tighten everything up. Biggest pain in the arse is the fact that I've lifted this in my garage and now it's too tall to fit through doors; will have to remove the 80" top so I can get it out. It does look good though.


Smackdaddy66

smackdaddy66

ImageUploadedByTapatalk1390132770.776264.jpgpretty happy with the results although steering radius has been decreased.


Smackdaddy66

deerhunter30

Looks good bud.