12 Stealth edge wont go

Moore1

Need help with a stealth hybrid edge just bought it and replaced all the batteries and on electric only runs about 10mph which may be right but on gas from what I read should run close to 20mph and it does good to do 10mph somebody with some knowledge of these things could help I would greatly appreciate it.

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

sunoco

Moore, I got your email. I get home from vacation tomorrow and will see what I can do

Moore1

Bump

CharleyL

If you repost this in the Electric cart sub forums, someone with electric cart knowledge should see it and help you. This sub forum is for gas carts and very few electric cart guys even look here.

You should also take the time to fill out your profile so we know more about you and your cart. Go to "User CP" in the left end of the second blue bar at the top of this page, click on it and add your info.

By the way, welcome to BGW. We'll get you going, once we can get you posting in the right place. There's a lot of experienced people here who love to help newbies.

Charley

sunoco

Moore, are you the customer in SC that I spoke to on the phone?


I believe there are only about 50 or 60 of this units that were built. I would personally remove the gas engine and go all electric. If you absolutely need the 4x4 we can convert it if you want to spend the money and go that route

These were not very well designed and there are no wiring diagrams. The rear axle should have an AMD 7144 or similar sepex motor on it. The controller is a Curtis 1268-5501 I think.. Post pictures of your motor and controller to confirm and lets go from there

Moore1

Motor is a d&d es-132-68 and controller is curtis 1258 5501

Attached Images

	20161228_155623.jpg (203.2 KB, 0 views)
	20161221_133613.jpg (143.3 KB, 0 views)

Moore1

Sunoco I believe I did speak to u I am in sc

sunoco

is there a speed sensor on the motor? wires coming out of the end and connected to wires going to the controller?

Moore1

Yes there is if I unplug it, it throws a flash code and want run but prob 4 or 5 mph. I pull the cover off of it and pulled the Allen screw out of the small wheel and the wheel has a hairline Crack in it. I called d&d motors and they said that wouldn't cause my prob but they would send me a new wheel out

Moore1

The main thing I think I need to know is what parameters this cart is suppose to be set at so I can take a scanner and check and see if there set correctly. I was getting a low voltage code earlier but I check voltage everywhere with a multimeter and for what I can tell it read right at 46 everywhere