03-22-2015, 08:26 AM | #1 |
Not Yet Wild
Join Date: Jun 2013
Posts: 21
|
73 D par cart reverse issues
I have a 73 D that I have replaced all wiring, starter generator, and most recently the forward reverse switch and cables. but one major problem still exists, the cart runs well in forward, but as soon as I switch to reverse and press the accelorator, the black wire from the generator to the voltage regulator heats up and melts, the cart never moves in reverse. any ideas?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-22-2015, 08:43 AM | #2 |
Gone Wild
Join Date: Jul 2014
Location: St. Paul Minneapolis MN USA
Posts: 522
|
Re: 73 D par cart reverse issues
You have a wire crossed somewhere or the wrong type of regulator. Do you have an electrical diagram for your cart?
|
03-22-2015, 09:33 AM | #3 |
Not Yet Wild
Join Date: Jun 2013
Posts: 21
|
Re: 73 D par cart reverse issues
yes, and I went over it a dozen times and it all looks good
|
03-26-2015, 08:45 AM | #4 |
Gone Wild
Join Date: Jul 2014
Location: St. Paul Minneapolis MN USA
Posts: 522
|
Re: 73 D par cart reverse issues
So it tries to run in reverse but the wire burns out? Once the wire burns out does it then run? Have you confirmed that when the wire is replaced that it is charging when running in forward?
|
03-26-2015, 10:14 AM | #5 |
Gone Wild
Join Date: Mar 2014
Location: Cedar Springs MI
Posts: 318
|
Re: 73 D par cart reverse issues
Have you check your ground wires for good contact? Main ground strap, and the solenoid ground too?
|
03-26-2015, 10:23 AM | #6 |
Gone Wild
Join Date: Jul 2014
Location: St. Paul Minneapolis MN USA
Posts: 522
|
Re: 73 D par cart reverse issues
The body to engine ground is basically just for the coil. The starter/gen is not grounded to the engine. It has to 'float' because of the reversing option. It gets grounded when needed to the correct terminal by the F/R switch.
|
04-05-2015, 03:00 PM | #7 |
Not Yet Wild
Join Date: Jun 2013
Posts: 21
|
Re: 73 D par cart reverse issues
all wiring and grounding looks good per diagram, replaced F/R switch, starter generator and voltage regulator, no longer fries black wire, but only "clicks" once when shifted reverse and accelerator is applied, will not move
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Reverse issues | Electric EZGO | |||
No reverse and other issues | Gas EZGO | |||
:help:HELP on non-dcs cart foward and reverse issues | Electric EZGO | |||
Yamaha G1 reverse issues | Gas Yamaha | |||
Wiring Issues - Reverse Buzzer | Electric EZGO |