|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
11-02-2015, 02:48 PM | #1 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
G1 questions
So I fixed the clutch and it is working great now but now I have another issue. When starting is it normal to have to give it a lot of gas before it starts moving? When it finally does it kinda jumps out. After driving it around for a while it gets a little better but still does that. Would this be a carb issue? Should I tune it up?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-02-2015, 03:04 PM | #2 |
Gone Wild
Join Date: Oct 2010
Location: Pittsburgh Pa
Posts: 1,551
|
Re: G1 questions
Your primary probably needs cleaned also. If your secondary was that bad then most of the time your primary will need cleaned and greased.
|
11-02-2015, 03:11 PM | #3 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: G1 questions
I just watched some videos and as soon as they give it gas it moves. Mine doesn't do that. I have to almost mash it all the way down before it moves. Once it's going for a bit it's ok but it still kinda jumps out. Do we have a primary clutch removal/cleaning thread out there? I tried searching
|
11-02-2015, 06:06 PM | #5 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: G1 questions
That happens when you lift them.
Try choking it and starting it at low throttle see if that helps. Its common at that age to have bad crank seals and cause starting problems. |
11-02-2015, 06:23 PM | #6 | |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: G1 questions
Quote:
https://flic.kr/p/zFhyZF https://flic.kr/p/AkyTaq https://flic.kr/p/zF9dHf |
|
11-02-2015, 07:00 PM | #7 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: G1 questions
"Jumping" sounds like primary clutch is sticking take it apart and clean and lube it up
|
11-02-2015, 07:04 PM | #8 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: G1 questions
I don't think I'm going to be able to open it up. I can't take the cover off because it hits the frame.
|
11-02-2015, 07:37 PM | #9 |
Gone Wild
Join Date: Oct 2010
Location: Pittsburgh Pa
Posts: 1,551
|
Re: G1 questions
Remove the bolts from the top of the rear shocks. Now push the shocks out of the way. That will allow the swing arm to move up and clear the outer frame. Make sure you put a jack under the rear bumper to hold the cart up.
|
11-03-2015, 09:01 AM | #10 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
Re: G1 questions
I just ordered the crank seals and the clutch puller. Might as well get these done
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G9 questions | Gas Yamaha | |||
07 EZ go questions | Electric EZGO | |||
questions | Gas Yamaha | |||
new to here, have a few questions | Gas Yamaha | |||
Pre-questions | Gas Club Car |