Yamaha drive (adding turn signals)

general01

Ok I am wanting to add turn signals on my dad's Yamaha drive cart

I already installed led lighting and noticed the cart had three wires going to the taillights


Is the g29(the drive) carts pre wired for turn signals from factory(I know the front lights only had two wires) if so can I use a universal turn signal stalk for them to work

He drives it to the local lake and most around here don't know hand signals at all(if they do they don't show it) and he had some nut go around him as he was signaling to make a turn(I had been ahead of him that day and didn't see it)

I may also add brake lights while I am at it for added safety as I sometimes drive the cart when I am not driving my club car cart

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

Shepard

If you were to use a turn signal switch like this ------ http://www.ebay.com/itm/One-Truck-Li...ZVpB~i&vxp=mtr ------ you would be able to set up brake lights and turn signals. You will have to add a brake light switch to your brake pedal. Remember -- the brake lights and turn signals operate on the same wiring being interrupted in the signal switch with a flasher unit for the turning direction.

general01

Thanks

I found one on eBay back of this when I was building my custom club car ds build and it supports the brake light function(though I used lights with separate brake and turn lights on it)

It's like my car where the brake a turn use the same light in the rear

I would like to have the fronts also do running and turn but I think I will get the turn signals working first