|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
07-28-2016, 05:48 PM | #1 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
G16 loud rear end
Noisy rear end in a g16 all stock for about a week as lift has been ordered
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-28-2016, 06:10 PM | #2 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,314
|
Re: G16 loud rear end
Check the input shaft bearing.
|
07-28-2016, 06:27 PM | #3 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,874
|
Re: G16 loud rear end
Could be as little as lack of grease in the sliding sheave bushing or the bushing is bad because lack of greasing. Does the noise sound like "growling"? Grease it and see if it goes away first. And check for play on the input shaft bearing like Dave said. Hope for the best
|
07-28-2016, 06:42 PM | #4 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
Re: G16 loud rear end
yes kind of a growling rattle
|
07-28-2016, 07:00 PM | #5 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,874
|
Re: G16 loud rear end
Grease the secondary sliding sheave 2 or three shots. Run it with the seat on (grease can be thrown around) then jacked up or in nuetral, watch the secondary to see if it "wobbles". You can really see the belt deflection if it's bad.
|
07-31-2016, 09:06 PM | #6 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
Re: G16 loud rear end
Greased 3 still made noise no wable at all clutch operated as normal greases 2 more times at 2 each noise went away 7 pumps total went around the block nice and quiet then started really loud went towards the house then it let loose. Secondary nut had backed off causing it all to come out the bottom I did find spring both plates and nut and washer but no keyway
|
08-06-2016, 07:58 PM | #7 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
Re: G16 loud rear end
Got that all fixed greased 3 shots went away for a mile or so now growling is starting back and I'm getting it jerking now. When I coast to a stop it acts like a downshift from 3rd to 1st where the tires chirp. And when accelerating it seems to not kick up rpms to go above stock speed then when it does growling comes back
|
08-07-2016, 06:23 PM | #8 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
Re: G16 loud rear end
noise is kind of growling or something grinding on a gear From rear end. it seems to surge in power a bit like it may have a weak spring I cannot get it to duplicate on stands or in neutral only while moving
|
08-07-2016, 07:58 PM | #9 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: G16 loud rear end
Take the cover off the primary clutch and check to see if there are flat spots on the rollers!!
Remove the seat, remove the belt, put it in gear, and push the car forward and backward to see if you can locate the noise!! Post pictures of clutches!! |
08-07-2016, 08:41 PM | #10 |
Gone Wild
Join Date: Mar 2016
Location: Owasso, OK
Posts: 190
|
Re: G16 loud rear end
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Rear end banging loud with 25 Inch tires on 6 in lift | Electric EZGO | |||
Loud pop in rear end now no go! | Electric EZGO | |||
'07 Par Car Loud Whine from rear | Columbia ParCar | |||
95 club 48v Loud Rear Noise | Electric Club Car | |||
G2 loud rear axle | Gas Yamaha |