|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-21-2017, 12:23 PM | #1 |
Gone Wild
Join Date: Sep 2015
Location: San Antonio, TX
Posts: 260
|
How to take body off G1?
I'd like to take the body off to have it painted. Should the top come off first? Are there any gotchas I need to worry about?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-21-2017, 12:38 PM | #2 |
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,948
|
Re: How to take body off G1?
Those bodies are very easy to take off. Yes, the roof will have to come off first.
Going from memory (I just painted mine last month) the backs are very easy. There are only some nuts / bolts through the frame and some more by the rear mud flaps. The the fronts are a bit more tricky as you have to take the steering wheel off to get the body off. You'll probably need a wheel puller for that. The actual front cowl is mostly held in place by bolts through the storage compartment up front and a couple of more through the foot area. You'll have to take the floor mat off. It's held in place by those push connectors that you'll have to pop off. That will likely ruin them and they'll need replaced. These are exact replacements: http://www.clipsandfasteners.com/sea...Search=pas1603 So long as the bolts aren't rusted in place it should be a 30 min job. I had to grind some frozen bolts so it took a bit longer for me. |
03-26-2017, 07:46 PM | #3 |
Not Yet Wild
Join Date: Mar 2017
Posts: 2
|
Re: How to take body off G1?
under the rubber inserts in the cubbies between the cupholders there are phillips head screws. the rubber pads are held in with push pins. use a large bit phillips to get these out. under the rubber floor mat are three bolts that are about an inch or so above the floor. use a small punch to drive the centers out of the plastic rivets and peel the rubber back. you will see the bolts. wheel has to come off. 17mm. ignition switch has to come out which is rather easy. spin the plastic nut. the choke cable has to come out which can be tricky. two screw hold the housing on and with the wheel off it will come right off. i had to cut a few wires as i had light switches and a radio housing. once all off this is out of the way you can fiddle the cowl off
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1987 DS Needs Body, will 2000 or newer body fit? | Electric Club Car | |||
wanted g-29 body or any body that can be made to fit | Golf Carts and Parts | |||
FS- Body Set off of '08 TXT | Golf Carts and Parts | |||
green body or camo dipped body | Electric Club Car |