|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-02-2017, 04:25 PM | #1 |
Not Yet Wild
Join Date: Aug 2014
Posts: 3
|
G1 doesn't stop when pedal is released
I've just replaced the stop switch which was expensive and apparently unneccessary.
The symptom persists. I have to turn off the main switch to kill the engine. This is a nuisance as I have a large brown dog that gets in the way. I live in the mountains and could use the engine as brake. Another thread said replacing the voltage regulator solved his problem. He did not elaborate as to how he determined it was the regulator or how it was causing the problem. I feel burned by my surmise that it was the stop switch. I might have used a meter to test it. And BTW replacing the stop switch is a nuisance as well. Anyway, can any one tell me how to determine whether the regulator is the problem. Can I simply brighten its contacts. Thanks,Cherrylogger |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-02-2017, 09:53 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G1 doesn't stop when pedal is released
Unhook the regulator wires, if all acts normal after that (minus charging).... Well , you know, you read the other one...
|
06-04-2017, 03:33 PM | #3 |
Gone Wild
Join Date: May 2011
Location: Pittsburgh
Posts: 2,941
|
Re: G1 doesn't stop when pedal is released
Get a wiring diagram and check the wiring from the key switch to the solenoids. It's possible to wire these carts to turn on with the key switch pretty much bypassing the start switch altogether.
I am assuming your issue is in both directions, right? If only one direction you may have a solenoid stuck closed. Yes, those stop switches can be tricky. I found is easiest to bend the plate below the switch downward and getting it from underneath. I then bend the plate back in place when done. |
Tags |
other?, stop switch, voltage regulator |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
G2 will not shut off when the gas pedal is released | Gas Yamaha | |||
gas pedal sticking after released | Gas Club Car | |||
Can I start and stop my vanguard with the pedal? | Big Block Talk! | |||
ST480 Workhorse won't stop running when gas pedal released | Gas EZGO | |||
89 starts when pedal released | Gas Club Car |