|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
05-28-2018, 02:23 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2018
Posts: 14
|
Need help with G2 Clone Belt Size
I just bought a 88 G2 'Basketcase'. The previous owner bailed out of the project but he installed a Predator 420cc with Comet 40 clutch, the secondary clutch is the original Yamaha. There is no drive belt on it but a Dayco HP2011 is in a box of parts. From what I've read the Comet uses 7/8" width and the Yamaha 1 3/16". I'm not sure if I want to keep the cart until I see how it works so I was thinking of just using a 7/8" belt and let it ride a little lower into the secondary. I can't move the engine more than an inch forward or back. Right now the distance between the shafts is 14 1/2" so no way the original Dayco belt will work. Anyone with any ideas for what I should do is appreciated. Thanks!
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Poweland clone belt size and driven clutch mods | Clone Engine Swaps | |||
| 2000 EZ-GO Workhorse - tire size? Belt size? | Gas EZGO | |||
| clone carb thread size in head? | Clone Engine Swaps | |||
| tire size for a 420 clone | Clone Engine Swaps | |||
| clone exhaust pipe size | Clone Engine Swaps | |||
Linear Mode
