|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-19-2018, 09:09 AM | #1 |
Gone Wild
Join Date: Jun 2013
Posts: 427
|
2015 Yamaha Drive G29-Ignition Wiring how to tap
I can't find the wire diagram that shows my carts (YDRAX5PTV4 - 2015)ignition switch.
But mine has 4 pins: Red Brown Red/White Red/Yellow Does anybody know what is what here? I am going to run a USB/Cigarette Lighter and a GPS Speedometer but I am not sure where to run the Positive of each to? I am just running both grounds back to the ground block. Any help please and thanks!!! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-19-2018, 07:19 PM | #2 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,875
|
Re: 2015 Yamaha Drive G29-Ignition Wiring how to tap
If this a PTV model with a 3 position key switch (off/on/lights) witch it sounds like, there will be a wire harness connector that has 12 volts +/- already. It will be covered in tape. Should be red and black wires. Good luck
|
06-20-2018, 02:08 PM | #3 | |
Gone Wild
Join Date: Jun 2013
Posts: 427
|
Re: 2015 Yamaha Drive G29-Ignition Wiring how to tap
Quote:
Still trying to decide if I want a dedicated switch for it instead |
|
09-12-2018, 09:44 PM | #4 |
Getting Wild
Join Date: May 2015
Posts: 96
|
Re: 2015 Yamaha Drive G29-Ignition Wiring how to tap
I’m having the same issue.. ever figure it out?
I found the always hot wires that were taped; but only want it on when cart is on. I am running a relay for battery, so just need an ignition wire to activate the relay. |
09-14-2018, 06:37 AM | #5 |
Gone Wild
Join Date: May 2011
Location: Georgia
Posts: 168
|
Re: 2015 Yamaha Drive G29-Ignition Wiring how to tap
This should be easy enough. Use a multimeter to determine which wire is switched. On my 2018 I was able to find switched 12V in about 2 minutes. Use common ground for MM ground lead, stip each wire just a small amount for MM positive lead and toggle switch until you find it. Tape up the small strip(s) you made to each wire and tap your switched wire with a t-tap.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2015 Yamaha Drive- AC or DC? | Electric Yamaha | |||
2015 Yamaha drive | Gas Yamaha | |||
2015 Yamaha Gas Drive - Plowmans Exhaust? | Gas Yamaha | |||
More speed from 2015 ac yamaha drive | Electric Yamaha | |||
2014 EZ-Go Gas or 2015 Yamaha Drive Gas | Gas EZGO |