|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-15-2009, 05:02 PM | #1 |
Not Yet Wild
Join Date: Jun 2009
Posts: 5
|
1993 g9
just tuned up cart, am getting oil blowing around the motor, i think it may be coming from head gasket, is this a hard job pulling the jug off and getting it back on, are there any special tools required. by the way hello everyone, i cuold not figure out how to say hi in intoduction forum, was excited about just posting a thread. thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-15-2009, 05:10 PM | #2 |
Gone Wild
Join Date: Nov 2007
Posts: 469
|
Re: 1993 g9
probably the valve cover gasket
4 screws & a bit of silicone I have never seen a head gasket leak on a Yamaha could be a hod one but not that bad of a job to change |
06-15-2009, 06:01 PM | #3 |
Not Yet Wild
Join Date: Jun 2009
Posts: 5
|
Re: 1993 g9
i have changed valve cover gasket, that is the one on very top, correct, oil seems to be coming from under to around half way down around motor and it is getting all over, like being sprayed around from wind or air movement, i am hoping it is not head gasket, could the block have a crack, thanks
|
06-15-2009, 06:02 PM | #4 |
Not Yet Wild
Join Date: Jun 2009
Posts: 5
|
Re: 1993 g9
does the motor have to be pulled to replace head gasket?
|
06-15-2009, 06:56 PM | #5 |
Raised by coyotes
Join Date: Nov 2008
Location: Central Texas
Posts: 5,658
|
Re: 1993 g9
dawpy, there is no "gasket" down there, the block and cylinder are one piece. There is a crankcase cover gasket, but it doesn't sound like that's the problem....Have you checked your air box setup? Also check the top and bottom rubber connections on the vent that runs up hte back of the engine to your valve cover.........
|
06-15-2009, 07:00 PM | #6 | |
doin it in the desert
Join Date: Dec 2008
Location: Sonora Desert,Az
Posts: 5,603
|
Re: 1993 g9
Quote:
|
|
06-15-2009, 07:05 PM | #7 |
Gone Wild
Join Date: Sep 2007
Location: maine
Posts: 3,352
|
Re: 1993 g9
no you can change head gasket with out pulling the motor. i would doubt it would be the head gasket. like cart de golf said. make sure you only have one quart of oil in the motor if more they will blow oil. the dip sticks are marked wrong on G9.
|
06-16-2009, 03:38 PM | #8 |
Not Yet Wild
Join Date: Jun 2009
Posts: 5
|
Re: 1993 g9
hello thanks for the responses, i am sure i have only 1 quart of oil in engine, i replaced the long hose from air filter box to valve cover with a soft hose and it kinks a little at bend, old hose was stiffer, i will change it and the one behind engine, it could be bad but oil does not seem to be coming from that area, but it could be blowing around fron there, not sure if i am looking at motor mount but seems to be more oil on it and around it, my cart is at campground and will be going there this weekend, thanks dan
|
06-16-2009, 04:15 PM | #9 | |
Gone Wild
Join Date: Sep 2007
Location: maine
Posts: 3,352
|
Re: 1993 g9
Quote:
|
|
06-16-2009, 07:34 PM | #10 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,868
|
Re: 1993 g9
Could be the side case gasket is "blown". Usually "blows" between the 2 bolts between were the dip stick is located. I could never tell when and if one would do it, but G2/G9/G8/G14's were all the same gasket. The gasket's have a sealer applied to them in the critical area's. Look real close at the engine were the dip stick is, alot of oil seepage?....most likly case gasket. Good luck Dave
|
Tags |
leaking oil |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
ezgo gas 1993-94 | Gas EZGO | |||
1993 G8 Won't Run | Gas Yamaha | |||
1993 ezgo | Lifted Golf Carts | |||
1993 36V CC - need speed | Electric Club Car |