|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-25-2011, 08:32 PM | #1 |
Not Yet Wild
Join Date: Mar 2011
Location: Phoenix Az
Posts: 22
|
G1 Clutch.......UGH!!!!
Ok, so I have done EVERYTHING I can think of and I CANNOT get the clutch off the crank.
1) Bought the puller 2) Penetrating Oil 3) Light Heat 4) Rubber Mallet 5) As much as I REALLY dont like to I even put a 1/2" Impact to the puller. Now What????!!!!!????? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-26-2011, 05:04 AM | #2 |
Gone Wild
Join Date: Jun 2009
Location: Heluvabump,VT
Posts: 623
|
Re: G1 Clutch.......UGH!!!!
Make sure the tool is screwing into the clutch properly and the end is bottoming out inside the crankshaft. Tighten down the tool- use the impact, but carefully. If you have a powerful impact and a high-volume compressor, you could start stripping things. Just zap it until the tool stops moving and there obviously is tension on the bolt. Now take a 2-3 lb. STEEL hammer and smack the end of the tool smartly. Don't be a wimp, give 'er hell. One hard smack square on the bolt head. It should pop right off.
|
03-26-2011, 07:40 AM | #3 |
I Refuse To Get Stuck!!!
Join Date: Jun 2010
Location: Hilton,NY
Posts: 5,427
|
Re: G1 Clutch.......UGH!!!!
Always grease the threads and put some on the end of the puller where it contacts the crank.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Tips & Hints for installing Clutch Tuning Kit, Removal of Drive Clutch | Gas Club Car |