|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
08-22-2013, 01:21 PM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2013
Location: TN
Posts: 26
|
G1 Starter Pulley
I purchased a new starter/generator for my '84 G1. The pulley on the new starter is considerably smaller than the original. Other than needing a smaller belt are there any negatives to using the smaller pulley? Seems like for the generator purpose it would be an advantage. But maybe starting power is compormised?
Any help or knowledge you can share would be appreciated. Thanks! |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-22-2013, 05:26 PM
|
#2 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: G1 Starter Pulley
What is the outside diameter of the two pulleys?
|
|
|
|
|
08-22-2013, 09:27 PM
|
#3 |
|
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G1 Starter Pulley
Also, greatly increases the likelyhood of over-revving the starter/generator at max cruising speed. Can the belt tensioner even tighten enough to put proper tension on the belt. It is probably possible to transfer the pulley off the old starter/gen, and i would try to do that.
|
|
|
|
|
08-23-2013, 11:37 AM
|
#4 |
|
Not Yet Wild
Join Date: Jul 2013
Location: TN
Posts: 26
|
Re: G1 Starter Pulley
Old pulley has an approx. 4 in diameter. The new one is about 2.5 in.
I put a 33 in belt on and I can get it fairly tight. |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Pulley OD for starter/gen RPM | Clone Engine Swaps | |||
| Starter pulley size | Gas Club Car | |||
| starter pulley spins but not the engine | Gas EZGO | |||
| 1992 yamaha starter pulley | Gas Yamaha | |||
| WTB: Pulley for yamaha starter | Golf Carts and Parts | |||
Linear Mode
