|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
08-06-2014, 10:11 AM
|
#1 |
|
Not Yet Wild
Join Date: Mar 2014
Posts: 31
|
G 16 tie rods
My g 16 has gotten pretty sloppy in the front end
tie rod ends are worn they all clunk when i grab the tire and push and pull. replacement ends are around 30 each i found the assembly rod and both ends for 45.00 why is this? i don't know if either are oem? but i don't think so has anyone found any replacement ends or made their own tie rods using parts from napa or such a store? i was thinking about heim joints from tractor supply or ebay at 5-10 bucks each am i beating a dead horse should i just buy the assembles and be done i take the wife and two kids on the cart running about 20 mph the steering is the only thing i worry about. please let me know what you guys have done also does anyone know what the threads are before i take it apart thanks Ken |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-06-2014, 03:36 PM
|
#2 |
|
maintaining a low profile
 Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: G 16 tie rods
http://www.golfcartking.com/Steering...show=27&page=2
I replaced my original tie rods with non-OEM assemblies, beat them up, and they are fine. |
|
|
|
|
08-06-2014, 06:49 PM
|
#3 | |
|
Admin/Moderator
Join Date: Dec 2006
Location: Ohio
Posts: 18,055
|
Re: G 16 tie rods
Quote:
 Steering is not the place to cheap out. |
|
|
Ron
 PLEASE VISIT Our Sponsors * BGW GEAR The Store The G2 Project * Swing Arm Drop & Repair * Geep1 Project |
||
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 81 g1 tie rods | Golf Carts and Parts | |||
| Tie rods | Electric Club Car | |||
| G16 tie rods | Gas Yamaha | |||
| ??? about rods | Gas EZGO | |||
| Tie Rods | Lifted Golf Carts | |||
Linear Mode
