ISO Pass side tie rod and ends 95 G9 Yami

kgsc

Just as the title states. Working on my G9 project and finally got around to installing the lift and fixing problems caused by the previous owner. Got everything installed and realized it was way out of wack. Turns out the pass tie rod had been replaced with the wrong one and it is way off. Pretty sure drivers is okay and correct but would like to replace the pass side and see if I can get this setup right..

What ya got ??

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

smallblock450sl

G2/G9 switched from large to small tie rod ends/tubes. Can you measure the the threads that screw into the tie rod end? Do you need RH or LH thread tie rod end?

kgsc

Sb I need the entire passenger side assembly. Ends and bar. It is much smaller diameter than the drivers side and I believe too long. I think the previous owner replaced it with something he could find instead of the correct part. I will get some measurements but I think I have a line on a replacement.

jmontes

I have both sides - A-arms, tie rods, shocks from a G14 if they are interchangeable... IDK

On edit... I may have a full front end out of my G2. I went to a Jakes LT kit.