Help! Needed Clutch for 2 PG or parts...

jay nesbitt · 10-17-2011, 08:52 PM

I put my 2PG back together Saturday . It was looking like might have a maiden voyage before sunset. Left the drive belt off for some run in time. Fired right off and ran about 30 secs around idle speed...when BAM...the clutch explodes....

I guess we started it in reverse...big mistake in retrospect....the movable sheave hit something when it let go and cracked the edge. I could try to weld it, but thought I'd look for a replacememt part.

SOOOOO....

I need the aluminum sheave for a Comet Duster (94 C, I believe?) or a complete clutch would also work...... The bore measures approx 1.059 in the cast iron (crankshaft side) clutch with a taper in the end.

Any help or info would be appreciated

thanks,
Jay

jay nesbitt · 10-20-2011, 10:26 AM

No one has a bad clutch I could get the movable sheave from?

Anyone have any info on clutch interchange? I have searched this site and came up empty handed.

I assume this is the 30mm (1.18 in) X 10:1 taper bore....although I get more like 26.9 mm....I mean other than the 1" and 1.18 straight shafts, how many bore sizes are used?

thanks,
Jay

jay nesbitt · 10-21-2011, 07:14 AM

Found one.
Thanks Guys,
Jay

10-17-2011, 08:52 PM	#1
jay nesbitt Not Yet Wild Join Date: Aug 2010 Location: Longview , Texas Posts: 49	Help! Needed Clutch for 2 PG or parts... I put my 2PG back together Saturday . It was looking like might have a maiden voyage before sunset. Left the drive belt off for some run in time. Fired right off and ran about 30 secs around idle speed...when BAM...the clutch explodes.... I guess we started it in reverse...big mistake in retrospect....the movable sheave hit something when it let go and cracked the edge. I could try to weld it, but thought I'd look for a replacememt part. SOOOOO.... I need the aluminum sheave for a Comet Duster (94 C, I believe?) or a complete clutch would also work...... The bore measures approx 1.059 in the cast iron (crankshaft side) clutch with a taper in the end. Any help or info would be appreciated thanks, Jay

10-20-2011, 10:26 AM	#2
jay nesbitt Not Yet Wild Join Date: Aug 2010 Location: Longview , Texas Posts: 49	Re: Help! Needed Clutch for 2 PG or parts... No one has a bad clutch I could get the movable sheave from? Anyone have any info on clutch interchange? I have searched this site and came up empty handed. I assume this is the 30mm (1.18 in) X 10:1 taper bore....although I get more like 26.9 mm....I mean other than the 1" and 1.18 straight shafts, how many bore sizes are used? thanks, Jay

10-21-2011, 07:14 AM	#3
jay nesbitt Not Yet Wild Join Date: Aug 2010 Location: Longview , Texas Posts: 49	Re: Help! Needed Clutch for 2 PG or parts... Found one. Thanks Guys, Jay

Similar Threads
Thread	Forum
Needed: G1 Parts!	Golf Carts and Parts
parts needed	Gas Club Car
ez go parts needed	Golf Carts and Parts
Parts Needed	Golf Carts and Parts
G1 parts needed.	Golf Carts and Parts

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum