Lift and steering question

CHADDYP

I have a CC DS and this thing steers like a log truck. We bought it used and it was already lifted with wheels and tires. Is there a difference in steering ease in a spindle lift versus a A-Arm lift? I am assuming we have a spindle lift on ours.

Our turns sharp to the left but turn really wide to the right.

Any help or advice would be appreciated.

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

StoveBolt

Sounds like you need to disconnect your tie rods, then center the steering wheel by turning it back and forth and finding the center. Then with your front wheels straight adjust the tie rods to fit back on. Sometimes you need to pull the steering wheel to center it too, if it's off.. Also keep in mind you need about a quarter to half inch toe-in on the front wheels. (wheels pointed in)

Warning: I'm an EZGO guy and know nothing about CCs but figured I'd give it a shot seeing no one is replying.

Welcome to Buggies.

smokindawg

I think Stovebolt is on to something. When they installed the lift they may not have gotten the steering arms correct.

I'd jack the cart up and then turn the wheels back and forth. Look good and figure out where the center point is for the lower steering arm off the box itself by turning it back and forth. Then adjust your steering arms accordingly.