Allsports Yamaha G1 Golf Car lift

TheNewGuy

I decided to go with an Allsports 4” lift on my Geep1 project. Thanks to CPP for the fast service. I like the lift, all of the components are of good quality, welds look good and the finish is very good. The install went well, the front went on without a hitch. All new Nylock fasteners are included with the kit. Not only does it raise the cart but moves the front wheels forward 2”. The rear required a small modification. Because all G1’s aren’t exactly the same, I had to switch the position of the new rear brackets due to the body restraint arm location. Instead of the pipe clamps being on the outside of the shock mount, I put them inside (right hand one on the left and vice versa). The mod was easy, just cut a notch in the corner of the new bracket to allow clearance for the body support. (see pics)
I haven’t had the cart on the road yet but I don’t for see any problems. More in a few weeks when I get this thing on the road.
Note: The two "Z" shaped pieces in the pic below are front bumper extensions and are not shown installed on the cart.

Allsports Golf Cart Lift Kits







Tie rod riser passenger’s side.



Body restraint arm where the pipe clamp could have gone on the rear.



I cut a notch on the inside of the brackets for clearance.


The outsides of these body supports just needed a little more room to seat when closed.



OH YEAH!!!

Ron


PLEASE VISIT Our Sponsors * BGW GEAR The Store

The G2 Project * Swing Arm Drop & Repair * Geep1 Project

BGW

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

ads245

Let me be the first to say "Very Nice."

dirtysouth

Very Nice Ron. When ya gonna have the body done???

groundpounder

looks good Ron. and thanks for all the info and pics.

Boris

Looks great Ron Lots of thought going into this one ......... Whats really amazing is the way photoshop makes that arrow look just like cardboard .... (jk)

dirtysouth

Don't listen to him Ron. That's a damm fine arrow...

TheNewGuy

I do things the old school way, that was faster than screwing around with photoshop!!

Ron


PLEASE VISIT Our Sponsors * BGW GEAR The Store

The G2 Project * Swing Arm Drop & Repair * Geep1 Project

Boris

Thats definitely something you'd hang on the wall for later use. Still a good job.

FFPudge

Mighty fine Ron! Wondering if you could combine this lift with the Jakes A-arm lift?

TheNewGuy

Thanks guys!! I hope to have the body done in a couple weeks.


I think it would work with an A arm lift.


I should have mentioned earlier, that I am also using Allsports 2" wheel spacers all around.
Very nice product, machining is top notch.

Ron


PLEASE VISIT Our Sponsors * BGW GEAR The Store

The G2 Project * Swing Arm Drop & Repair * Geep1 Project