Buggies Gone Wild Golf Cart Forum

Buggies Gone Wild Golf Cart Forum (https://www.buggiesgonewild.com/index.php)
-   Electric golf carts (https://www.buggiesgonewild.com/forumdisplay.php?f=33)
-   -   install throttle hall curtis controller (https://www.buggiesgonewild.com/showthread.php?t=80343)

zamahuikano 05-19-2013 02:13 AM

install throttle hall curtis controller
 
:?I want to change the throttle potentiometer 5k resistive Hall Effect other on my Curtis 1236. I tried in the configuration types 2-3 and 4 and the controller does not recognize and indicates an alarm.
Anyone know a way to adapt the accelerator hall and does not indicate the controller alarm. I think the controller to detect no load "5k" potentiometer itself goes into alarm. Any ideas ....

zamahuikano 05-20-2013 08:34 PM

Re: install throttle hall curtis controller
 
:thumbup: problem solved:
Finally I was able to connect the accelerator hall and works perfect. This will supply voltage with +5 v (pin 26) and gnd (pin7) and the output signal (pin 16).

I've set the type 2 for 0-5V voltage source and then calibrate it with:
Forward Deadband, Forward Map, Forward Max y Forward Offset
I had the accelerator hall well connected but I was alarm the problem was that was turned on to "1" the protection HPD / SRO, disconnect and set to 0:

HPD / SRO Type 0-3 Determines the type of HPD / SRO protection. One type of checks is available for materials-handling vehicles, and two types for golf-style vehicles.
If any of the HPD / SRO checks finds an input sequencing problem, and HPD / Sequencing Fault (flash code 47) is set.


All times are GMT -5. The time now is 10:55 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.