FSIP Controller Question 3 wire
I hope everybody is doing well.
My current cart is an 03 series 48 volt with a mcor 5-0k that feeds my current controller. If I have a mcor is it compatable with a FSIP series controller that the input is a 3 wire for a vglide? I have looked at the FSIP info and can't really determine this? The PN for the FSIP is 51-60L 700 NNVSS2. 700amp 72 volt series controller. The low cut off is 25 volts so it should work with my 48 volt cart. But my concern is the "V" in the PN. is the 5 and V below interchangeable? ARG 6 Accelerator Input 0 - 0 to 5K Ohms 5 - 5K to 0 Ohms V – 3-wire 5k pot, Club Car V-Glide S – Special setting Thanks! Steve |
Re: FSIP Controller Question 3 wire
So I guess I should have asked this also.
48/72V: 25V cutout Can a 48 Volt cart hauling butt or pulling a hard load ever get below 25V to cause this controller to cut off? Thanks, Steve |
Re: FSIP Controller Question 3 wire
Stealth was using an MCOR with the controller.
96+ V-Glides are 5k-0 as well |
Re: FSIP Controller Question 3 wire
MCOR = 3-wire. I've used this controller on several vehicles. It works great with the MCOR.
|
Re: FSIP Controller Question 3 wire
Thanks David!!
|
All times are GMT -5. The time now is 02:49 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.