I have a 92 ezgo marathon that has a textron motor, but the motor controller had water damage. The controller was a Curtis pmc 0–5kΩ model 1204-009. Voltage 24-36. Current 275 amps. I recently purchased a replacement controller (model 1204x-4214), but it was not compatible because j1 prong was missing and ksi was instead part of the 6-pin module molded into it (attached in the last 2 photos) Don’t want to make this mistake again. I found another one on eBay (1st two photos attached), can anyone tell me if this one will work? The one I found is Curtis pmc 5k-0Ω model 1204-412. Voltage is 36-48. Current is 300 amps. Also this ones description says 5k-0Ω instead of 0–5kΩ. Not sure if that matters. I do not want to upgrade the solenoid or fnr switch. Just want to make sure going from 275 amps to 300 amps won’t cause any issues. Already upgraded to 4 gauge cables.
0E17C7F9-F66D-4C6C-A825-10D5EDD31D43.jpg
ED704474-2DD0-4937-A64C-48DF2EBE8EFD.jpg
C91C90BD-259D-4EDA-A0A8-289DC4884339.jpg
4AD19F22-3874-44B3-AB02-D6372F449CC8.jpg