Buggies Gone Wild Golf Cart Forum - View Single Post - 1991 Club Car

AirJunky · 02-27-2011, 01:06 PM

When I built my engine mount, I slotted the holes side to side so I could get the belt alignment exactly right. But I didn't slot them front to back at all to adjust for belt tightness. As a result I've had to figure out which belt is right.... 2" longer than stock. It's a belt from a Polaris snowmobile.
Because I used the stock generator/starter, I don't think I would have been able to go much shorter or it would interfere with the throttle linkage.

02-27-2011, 01:06 PM	#7
AirJunky Gone Wild Join Date: Jul 2009 Location: Liberty Lake, WA. Posts: 1,762	Re: 1991 Club Car - Clone When I built my engine mount, I slotted the holes side to side so I could get the belt alignment exactly right. But I didn't slot them front to back at all to adjust for belt tightness. As a result I've had to figure out which belt is right.... 2" longer than stock. It's a belt from a Polaris snowmobile. Because I used the stock generator/starter, I don't think I would have been able to go much shorter or it would interfere with the throttle linkage.