RXV Danaher to Curtis Conversion Instructions
Before I upgraded my RXV controller to the 350 amp Curtis, I searched everywhere for the install / conversion instructions just so I could see what i was getting in to. I was unsuccessful in finding them anywhere on the web so I figured I would post them on here now that I have done the conversion.
If you are going to do the conversion make a note that on page 2, step 16, they show the resistor wire being ran on to the end / stud of the resistor. IT IS WRONG. I am not sure why they show it connecting up like this, but it should be hooked to the end of the coil on the tab, just like the other end.
The install was pretty easy, the hardest parts was getting to the bolts in the floor panel holding the old controller in place. If anyone has any questions let me know. Or if anyone knows a better place for the PDF feel free to move it.
To be clear this is EZ-Go Part # 750566PKG
4 - 12v Batteries
Conversion from stock Danaher to 350amp Curtis controller.
|