Quick HD leaf spring pack build
We put this leaf spring pack together for a customers cart that we will be working on tomorrow. He has a 2007 Club Car Precedent with a rear seat kit and he loads it up quite heavily. We felt this would be a great solution as oppose to the HD spring system. We were quite pleased with the results after completing them, they stiffened up the single factory spring nicely but we believe it will give the cart a nicer ride over an HD spring setup.
We started with 4 factory springs, the cut the eyes off of each end of 2 of them. We then rounded the corners off for a nice finish. We then needed a longer bolt, we then lathed the head of the bolt down to fit in the lower leaf assembly, we re used the factory nut. We then clamped the springs together and drilled 3/16" holes at each end to fasten the springs together so that the customer does not get the "clack, clack, clank" over the bumps. We then cleaned and prepped them for paint and give them several coats of paint so that they will hold up over time.
Thanks for looking!
|