|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-26-2020, 08:17 PM | #1 |
Not Yet Wild
Join Date: Mar 2020
Posts: 2
|
4 Green 6 Red alltrax dcx 400
Hello cart enthusiast,
I have a 97 ezgo converted to 48V in 2009 by High Desert. Its equipped with a DCX 400 alltrax controller. Found a dead forward limit switch and i jumped it worked good for a while. Then i let it sit and back to the same code 4g 6 r. I found that if i ground the solenoid #7 blue wire the solenoid will click. Under voltage is not the issue. Tomorrow i think ill test the limit switch in the I T S. Anyone have this problem? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-27-2020, 10:05 AM | #2 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 4 Green 6 Red alltrax dcx 400
Quote:
Measure the voltage between the controller's B- and B+ terminals after solenoid clicks. That is the voltage the controller thinks is lower than it ought to be. If that is greater than what the under voltage slider is set for, measure the voltage between the controller's B- terminal and Pin-9, then between B- and Pin-10. If the voltage on either of those two pins is not the same as the battery pack voltage, you'll get a under voltage error. BTW: the four green flashes are not part of the error code. The indicate the DCX is programmed for an EZGO ITS type throttle. |
|
03-30-2020, 06:31 PM | #3 |
Not Yet Wild
Join Date: Mar 2020
Posts: 2
|
Re: 4 Green 6 Red alltrax dcx 400
Hey thanks
I cant get the solenoid to click. I have 49 volts on all four posts. If i ground the blue wire on the negative side Of the solenoid ( small post) it will click and run fine But unsure if that is safe. There is no diode but there is a 250 ohm resistor I did check voltage B- to 9 and 10 post and both are at 49 volts |
03-30-2020, 07:25 PM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 4 Green 6 Red alltrax dcx 400
The solenoid''s contacts are supposed to be open when pedal is up and closed when pedal is pushed, so connecting the blue wire on the solenoid coil to B- is a safety issue.
The two most likely possibilities are, bad coil driver in the controller or a bad pedal switch circuit (circuit = switch plus wiring). Check the voltage on Pin-5. Should be battery pack voltage when pedal is pushed. |
Tags |
ground #7 pin, no click, solenoid |
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax XCT 1 Green/1 Red Open/Short Circuit | Electric EZGO | |||
2013 G29, upgraded to Riot Kit - no green LED on Alltrax | Electric Yamaha | |||
Alltrax SPM 48300 1 red 1 green error | Electric EZGO | |||
Alltrax SPM 48300 EZ 4 blink green | Electric EZGO | |||
Alltrax SR controller. What is the green spade connector port for? | Electric EZGO |