crank seal in the clutch and fan side of a G1.

[chuddly]

So here is a quick walk though putting crank seal in the clutch side of a G1.



Step 1. remove the gas tank


Attachment 42603




Step 2. remove the outer clutch cover via the Phillips head screw

Attachment 42604


Step 3. Remove the long bolt holding the outer clutch plate one (7/8" head)Remove the outer clutch plate


Step 4. Remove the drive belt and starter belt.

Attachment 42605





Step 5. Using a clutch puller (can be bought or you can make your own. I bought mine) remove the inner clutch plate/shaft

Attachment 42606




Step 6. Remove the oil pump gear housing and pull BOTH the inner and outer housing off of the engine case

Attachment 42607

Step 7. run a screw into the seal and using a claw hammer pry the old seal out.

Step 8. put the new seal in (put some oil on the part of the seal where it slides on the crank shaft to keep it from catching and tearing).

Step 9. Reinstall everything the way it came off.

Hope this helps



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~



http://www.buggiesgonewild.com/gas-y...-fan-side.html





,