|
Drivers Clubs Club Car/Ezgo/Yamaha/etc. |
|
Thread Tools | Display Modes |
04-27-2009, 07:19 PM | #1 |
Not Yet Wild
Join Date: Apr 2009
Posts: 4
|
converting a 1985 club car to use a controller
I have a 1985 36v Club Car. Being new to the golf cart world I was given the age of my golf cart to that of the mid to later 90's when someone had purchased it for us. I however through research, have found that I do not have a motor controller but have seperate solenoid/resisters that run it. Problem is, in my excitement to upgrade it's sluggish drive up hills, I Purchased an Alltrax 36-48 NPX 400-amp controller. Does anyone have ideas on how or if I can convert my cart to use a controller instead of the five solenoids/resisters. Will this motor which i believe is a series wound work with the controller. I do not want to "break the bank" with money. Thank you.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1985 club car | Electric Club Car | |||
1985 club car | Gas Club Car | |||
Question converting VGlide&coils to Vglide&controller | Electric Club Car | |||
Converting a '92 coil resistor to a electronic controller | Electric Club Car | |||
1985 Gas Club Car | Gas Club Car |