|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-28-2010, 10:42 PM | #1 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
|
ITS questions
Does anybody know if putting 48v to an Inductive Throttle Sensor will screw up the output?
I put 48 instead of 36v to it and the cart runs at about 1/3 speed. Changed it out with 2 other units... same thing. Changed controller & solenoid same result? 48v conversion series TXT. Alltrax AXE 3 wire connection. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-28-2010, 10:46 PM | #2 |
Gone Wild
Join Date: Dec 2009
Location: Gastonia NC
Posts: 530
|
Re: ITS questions
hold on to your jockys scotty sunKing will be here soon...
|
02-28-2010, 10:53 PM | #3 |
Gone Wild
Join Date: Mar 2008
Location: Rockwall, Texas (Dallas / Ft. Worth)
Posts: 7,077
|
Re: ITS questions
Never done a conversion, so I'm no help Scotty!
|
|
|
02-28-2010, 10:56 PM | #4 |
Gone Wild
Join Date: Dec 2009
Location: Gastonia NC
Posts: 530
|
Re: ITS questions
sorry scotty i just had to...
|
02-28-2010, 10:57 PM | #5 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
|
Re: ITS questions
OH LORD! This has got me wondering.... the controller was bench programmed and the rechaecked after it didn't work right, another programmed and installed? 3 ITS units tried? ITS output will not come up to be read as stated in the Ezgo manual?
Ezgo manual says: Key on In gear DVM on volts neg test probe on battery pack neg pos test probe into white output wire read.45 - 1.5 volts through out the peddle travel I get nothing but, the motor runs at diminished speed WTF ????? |
02-28-2010, 11:28 PM | #6 |
ZONE FREE ZONE
Join Date: Nov 2009
Location: lauderdale by the sea
Posts: 571
|
Re: ITS questions
check your ground off the its
|
02-28-2010, 11:31 PM | #7 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
|
Re: ITS questions
can you explain that? How You mean the rod that moves into the hole should have a good ground?
But grounded to what? It is a 4 wire harness, power in and power out of the micro and 2 throttle signal wires? |
02-28-2010, 11:35 PM | #8 |
Gone Wild
Join Date: Dec 2009
Location: Gastonia NC
Posts: 530
|
Re: ITS questions
its only has two wires and both from the controller right..so were is the ground
|
02-28-2010, 11:37 PM | #9 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,356
|
Re: ITS questions
Right a 2 wire throttle indication system? Like a pb-6 but working in voltage .5 -1.5 basically
|
02-28-2010, 11:40 PM | #10 |
ZONE FREE ZONE
Join Date: Nov 2009
Location: lauderdale by the sea
Posts: 571
|
Re: ITS questions
ok i just ran out and looked at mine. your right there is no grd.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
More Questions | Gas Club Car | |||
New Guy Questions | Electric EZGO | |||
few questions | Electric Club Car | |||
More questions | Gas EZGO | |||
oil questions | Gas EZGO |