90% complete with leaf build /install -Few questions

[jeffro22]

first off thanks to all the detailed write ups that have been posted. Been a huge help and really appreciate all the build threads

I finally Built a 14 cell leaf pack and just dropped it in my precedent today. Still a little unsure on finalizing some of the wiring.

-I am using the Chargery BMS 16

-Have to MZJ400 to use in place of the gigavac for the HV/LV disconnect. -DO I still need any additional relay? Was thinking no. I understand the 2 large terminals on the disconnect will be wired inline with the main positive cable before the shunt. Does it need the resistor between these terminals?

How do I wire the smaller terminals and I do use the flyback diode here, correct?

I have 4 wires coming out of my bms for the HVLV. I have red/black and red/black. How do I wire this correctly?

where do I attach the 2 wires (red and black ring terminals) for current sensor from the BMS? Looks like both sides of the shunt. Does it matter which one goes on which side?

[jeffro22]

Found this which helps a little bit noticed it shows the shunt Inline with the b- from the pack. I have mine mounted inline with b+

[woolybaseball]

Chargery recommends the shunt to be on the B- side of the pack. Also less chance of accidentally grounding it out with a wrench or something if its on the B- side.