|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-04-2008, 05:16 PM | #1 |
Not Yet Wild
Join Date: Jul 2008
Location: Griffin, Ga
Posts: 33
|
need help!!!! can't build any RPM's????
here is what I have...96 club car
brand new Kaw FE-290 motor 5 weeks old brand new Kaw Carb installed today brand new drive belt 5 weeks old all new fuel filters and hoses 5 weeks old new air filter 5 weeks old no rev limiter installed Govenor disabled tie-wraps on throttle spring adjusted pedal to where engine starts after 3/4 inch adjusted throttle cable out of the black box to remove all slack 6" lift 22x11x10 sod busters runs decent until in a bind or climbing any sort of a hill new motor was weak and smoking so I replaced it and everything that helps one to run...used original carb but new it was filthy so I replaced it thinking that would help with the engine bogging down...helped some but not much... what settings or adustments am I missing??? is there a way to make an adjustment that allows the carb to be opened more???? it apears that only about half the throttle is being opened...I can reach down a pull the throttle cable with my hand past where it goes using just the pedal..... I am just about at my wits end..I have read as much as I can, replaced everything that I could,,,,,I just cant get this thing to build any R's this thing should be a hill climbing little bugger....at least better than what it is right now.... any help would be appreciated |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-07-2008, 07:53 PM | #2 |
WILD
Join Date: May 2007
Location: lebanon county,pa
Posts: 1,266
|
Re: need help!!!! can't build any RPM's????
Well replacing parts left and right never solves anything, what do you mean new motor rebuilt, fresh out crate or what?Check the plug and replace if it is messed up.Report back what the plug looks like.
|
09-07-2008, 11:52 PM | #3 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: need help!!!! can't build any RPM's????
Does the peddle open the throttle all the way? Is ther more? Can you open it further by hand?
|
09-09-2008, 11:16 PM | #4 |
Gone Crazy
Join Date: Jan 2007
Location: Chesterfield, Va
Posts: 6,021
|
Re: need help!!!! can't build any RPM's????
No mention of new exhaust, unbolt it and see how it runs.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
How many RPM's??? | Extreme DC! | |||
RPM's... | Gas Yamaha | |||
CP-build | Announcements | |||
What would you build ? | Electric Club Car | |||
Want to build a new one | Golf Carts and Parts |