Test

10.5Dart · 11-23-2013, 11:28 AM

1998 Ez-Go Workhorse

Cart was just finished after being stripped down to frame. Body was painted gloss black by a local shop.

Cart has a 23 hp Briggs and Stratton Vanguard V-twin engine on a Vegas carts cradle, has a K&N filter and a CPP stainless exhaust. Also has a new Comet 94c clutch and belt. All brand new wiring with off road lights.

Black powder-coated Strech long travel front suspension.

All new steering rack, tie rod ends, spindles, rear leaf springs, bushings and Monroe air shocks. Steering is super tight.

Rides on a brand new set of 27x12x10" Dirt Devil tires. Has billet 2" wheel spacers in rear to match front width.

Brand new black stitched seats, wood base and seat back. Has diamond plate rubber floor mat to match the black diamond plate rocker panels.

Cart looks and runs great. Lots of power and will run about 30mph. I also have a CPP rev-kit for the engine, but have not yet installed it.

The bad: The bed is a bit rusty beneath the bed liner. It doesn't affect the operation of the bed and it is still 100% useable, but I want to disclose the only issue the cart has.

I have over 5k invested, but I want to sell to start a new project.

Asking $4,500.00 or best offer. Cart is located in Cape Coral, Florida.

11-23-2013, 11:28 AM	#1
10.5Dart Not Yet Wild Join Date: May 2011 Location: SW Florida Posts: 42	Test 1998 Ez-Go Workhorse Cart was just finished after being stripped down to frame. Body was painted gloss black by a local shop. Cart has a 23 hp Briggs and Stratton Vanguard V-twin engine on a Vegas carts cradle, has a K&N filter and a CPP stainless exhaust. Also has a new Comet 94c clutch and belt. All brand new wiring with off road lights. Black powder-coated Strech long travel front suspension. All new steering rack, tie rod ends, spindles, rear leaf springs, bushings and Monroe air shocks. Steering is super tight. Rides on a brand new set of 27x12x10" Dirt Devil tires. Has billet 2" wheel spacers in rear to match front width. Brand new black stitched seats, wood base and seat back. Has diamond plate rubber floor mat to match the black diamond plate rocker panels. Cart looks and runs great. Lots of power and will run about 30mph. I also have a CPP rev-kit for the engine, but have not yet installed it. The bad: The bed is a bit rusty beneath the bed liner. It doesn't affect the operation of the bed and it is still 100% useable, but I want to disclose the only issue the cart has. I have over 5k invested, but I want to sell to start a new project. Asking $4,500.00 or best offer. Cart is located in Cape Coral, Florida.

Similar Threads
Thread	Forum
Test	Test Post
test	Test Post
Test. Test. 123. Is this thing on?	Test Post
test	Test Post

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum