1990 Club car With flat head Rev limiter question and govenor question
I have a 1990 Club car with a flat head I just ordered the clutch spring power kit and Im wondering if there is a way to get rid of the rev limiter and what should I do with the govenor
Thanks for the help Guys |
Re: 1990 Club car With flat head Rev limiter question and govenor question
I read the stickys and did some searching I just could not find much on the flat head and I dont see a rev limiter box any were,just a coil!
|
Re: 1990 Club car With flat head Rev limiter question and govenor question
Sounds like you are trying to do every thing you can to blow that motor, that 20 year old flathead aint built for speed and high rpm's. But if thats what you want to do its your buggy, just my .02. The governor is the rev limiter. Big Block might be in your future.
Good luck |
Re: 1990 Club car With flat head Rev limiter question and govenor question
Quote:
i have to add i agree............................................8 ) |
Re: 1990 Club car With flat head Rev limiter question and govenor question
Quote:
Chris:? |
Re: 1990 Club car With flat head Rev limiter question and govenor question
Ok got cha Well the govenor is already unhooked at the carb can you guys tell me how it should be adjusted then I can hook it back up,I talked to a guy that said it has to be hooked up and you could bend it to get the results you wanted.
Thanks for the help |
Re: 1990 Club car With flat head Rev limiter question and govenor question
When Gov Arm is at rest it should be parallel with the rear axel.
"Gov Rod" Straight end goes in Gov Arm, 90 deg bend end goes in Throttle Plate Pivot Lever. Should be a plastic bushing in Throttle Plate and spring clip to hold rod in Throttle Plate Loosen Rod bolt at Gov Arm Push Throttle wide open and hold there. Pull Gov Arm towards the Carb till it stops and hold there "It dosen't move very far" Tighten bolt at Gov Arm. Good Luck |
Re: 1990 Club car With flat head Rev limiter question and govenor question
Thanks a ton,so what engine swap if any would you guys say to use.
|
Re: 1990 Club car With flat head Rev limiter question and govenor question
Tough question, I hear good and bad about any and all of them. If I had to choose I would do the Vanguard.
|
All times are GMT -5. The time now is 09:24 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.